ELRO DWH SERIES Manuel d'instructions télécharger pdf (Page 13)

INSTALLATION

Setting the Camera Channel (Optional)

Pairing the Camera to Receiver (Optional)

Follow the steps in Camera Setup section (p.20) to setup or change the

channel of the camera. If you are adding another

camera to link

with the

supplied

monitor in this kit, then ensure its channel is set to a different

channel to the existing camera(s).

Note:

The wireless camera will be supplied preset to channel 1.

The monitor supports up to 4 cameras. Follow the steps below in

Camera Setup section (P.20) to setup or change the monitor channel of

the camera. If you are adding another camera to link with the supplied

monitor in this kit, then ensure its channel is set to a different channel to

the existing camera(s).

If the camera is located with in 1m to 1.5m from the monitor and the

camera's volume on the receiver is turned on, then you may hear a

whistling noise on the monitor which is the feedback picked up by the

microphone. In this case please locate the camera further away from

the monitor to prevent this noise.

If the power connection to the camera is kept outdoors, ensure the

connection is suitably protected.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 38 39

Pas de commentaire

ELRO DWH SERIES Manuel d'instructions Page 13